🚨 Important Notice:
1️⃣ This product requires a Tuya Zigbee 3.0 Gateway for proper use!

2️⃣ This product is battery-powered, but batteries are not included.
 
🔥 Quick Introduction:
1️⃣ This is an intelligent WiFi Photoelectric Smoke Sensor, capable of real-time smoke detection. When smoke is detected, the sensor's red LED lights up and an alarm is triggered.

2️⃣ The alarm helps protect you and your family by providing an early warning. It is ideal for use in homes, lounges, cafes, dance halls, and other locations that require fire hazard monitoring. (Note: This sensor does not detect gas or heat.)
 
🌟 Key Features:
🔋 Ultra-low energy consumption: Powered by AAA batteries (not included) with a lifespan of 6 months, reducing the need for frequent replacements. No wiring required!
 
🔊 Loud 90dB Alarm: Ensures people can react in time to potential dangers.
 
📱 Mobile App Alerts: Receive instant notifications on your phone, allowing you to act quickly and prevent damage or loss.
 
🔥 Smoke detection alerts: Immediately warns you of high smoke concentration to minimize risk and avoid economic loss.
 
🛠️ Recommended Installation:
Flat Ceiling Installation: The best location is in the center of the ceiling, as smoke, heat, and combustibles rise and spread. Keep the sensor at least 30cm away from lights or other decorations.
 
Sloped Ceiling Installation: If installed on a sloped roof, place it 90cm horizontally from the slope. Ensure the slope angle is less than 45°, and maintain a distance of 50cm from the highest point.
 
📉 Other Functions:
Low Battery Reminder: When battery power is low, you will receive a notification to replace them.
 
Offline Alerts: If the sensor goes offline, the app will remind you after 30 minutes.
 
📋 Specifications:
App: Smart Life (Tuya App)
Material: ABS Plastic
Wi-Fi Standard: 802.11 b/g/n
Power Supply: AAA batteries (not included)
Detection Range: 20m²
Standby Current: ≤10uA
Installation: Ceiling-mounted
Alarm Current: ≤120mA
Operating Temperature: -10°C to 50°C
Low Voltage Warning: ≤2.4V
Humidity Range: ≤95%
Alarm Volume: 90dB at 1 meter
Size: 90x90x40mm
 
📦 Packaging:
Net Weight: 0.081kg
Gross Weight: 0.1kg
Package Size: 90x90x40mm
 
🚨 重要提示：
1️⃣ 本产品需要搭配 Tuya Zigbee 3.0 网关使用！

2️⃣ 本产品使用电池供电，不包含电池。
 
🔥 快速介绍：
1️⃣ 这是一款智能 WiFi 光电烟雾传感器，能够实时检测烟雾。当探测到火灾烟雾时，传感器的红色 LED 灯会亮起，并发出警报。

2️⃣ 警报可以及时提醒您和您的家人。适用于家庭、休息室、咖啡馆、舞厅及其他需要火灾警报监控的地方。（注意：此传感器无法检测气体或热量）
 
🌟 主要卖点：
🔋 超低能耗，电池供电：使用AAA电池（不包含），电池寿命约6个月，无需频繁更换电池。无需布线。
 
🔊 90dB 强力警报：可让人及时反应并快速处理潜在危险。
 
📱 手机APP推送警报：让您远离潜在危险，避免经济损失。
 
🔥 烟雾检测提醒：及时提醒您烟雾浓度危险，消除隐患，避免财产损失。
 
🛠️ 推荐安装位置：
平顶安装：烟雾传感器的最佳安装位置是天花板中心，因为烟雾、热量和可燃物会上升并横向扩散。请保持至少30cm 远离灯具或其他装饰物。
 
斜顶安装：如果天花板有倾斜，请在距离吊挂物90cm 的水平位置安装传感器。倾斜角度不应超过45°，距离顶点50cm。
 
📉 其他功能：
低电量提醒：当电池电量不足时，手机会提醒您更换电池。
 
离线提醒：当设备离线时，APP将在30分钟后提醒设备已离线。
 
📋 规格参数：
应用程序：Smart Life（Tuya App）
材质：ABS塑料
Wi-Fi标准：802.11 b/g/n
电源供应：AAA电池（不包含）
检测范围：20平方米
待机电流：≤10uA
安装方式：天花板安装
报警电流：≤120mA
工作温度：-10°C 到 50°C
低电压提醒：≤2.4V
湿度范围：≤95%
报警音量：1米处90dB
尺寸：90x90x40mm
 
📦 包装：
净重：0.081kg
毛重：0.1kg
包装尺寸：90x90x40mm